Fuel Additives
Engine Flush
SKU: SVFA0301350 mlengine_oil
A pre-oil-change cleaner added to the old engine oil to dissolve sludge and varnish so they drain out with the used oil. One 350 ml bottle per sump of up to 5 L, 10 minutes at idle.
Login to request technical documents (TDS / MSDS)
Key Features
Removes Sludge: Dissolves sludge and varnish before the oil change.
Cleans Oil Passages: Rings, lifters and oil galleries.
Cleaner New Oil: Fresh oil stays clean longer.
Seal-Safe: Mineral-oil based, no aggressive solvents.
All Motor Oils: Mineral, semi- and full synthetic.
Gasoline & Diesel: 1 bottle per sump up to 5 L, 10 minutes idle.
How to Use
1
Warm the engine to operating temperature, then switch off.
2
Add the full 350 ml bottle to the old engine oil through the filler cap (2 bottles for 5–8 L sumps).
3
Run the engine at idle for 10 minutes – do not drive or rev.
4
Switch off and drain the oil completely while warm.
5
Replace the oil filter, refill with fresh oil; store the product closed at 5–40 °C away from children.
Product Details
SOLVAR Engine Flush is a 350 ml pre-oil-change cleaner for gasoline and diesel engines, added to the old engine oil just before draining.
Based on high-flash mineral base oil with an ashless polyisobutylene-succinimide dispersant, it dissolves and disperses sludge, varnish and oxidation residues from piston rings, oil passages and hydraulic lifters so they drain out with the used oil. It contains no chlorinated or aggressive solvents, so it is gentle on seals during the short cleaning time.
Add one bottle per sump of up to 5 L, idle 10 minutes, drain, change the filter and refill – the fresh oil stays cleaner for longer. Compatible with mineral, semi- and full-synthetic oils. Manufactured by CHEMIX LAB – New Borg El Arab, Alexandria, Egypt.